Washer error codes

Use the model's documented Control Lock or Child Lock button hold to unlock the panel.

Check for clothing caught in the door and inspect the latch area.

Open and close the drawer or door firmly, then stop if the latch area looks damaged.

Restart a short cycle only after the latch area is clear and the door closes normally.

Check for clothing or packaging film blocking the lid or drawer, then close it firmly.

Confirm the paired unit is aligned and stop if the switch or installation looks damaged.

Cancel the cycle and turn off water supply if filling continues.

Open both supply valves fully and check fill hoses for kinks or frozen sections.

Reduce the load, let the washer rest, and retry a short cycle only if the drum moves freely.

Check the drain hose and clean the accessible pump filter before repeating the cycle.

Unplug the washer and arrange service if PE returns, because the water-level sensing path needs diagnosis.

Let the washer reduce suds, then use less HE detergent on the next load.

Disconnect power and request service if the same tE code returns after one reset.

Redistribute heavy items and run a spin test with a balanced load.

Check for a clogged drain hose, pump filter, or slow household drain.

Remove laundry from the latch area and avoid forcing the locked door.

Reduce the load and verify the basket can move freely before retrying.

Open supply valves, check fill hoses, and clean inlet screens if safe.

Check whether the detergent drawer or cartridge is clogged before retrying.

Check the drain hose height, kinks, and accessible pump filter before retrying.

Let suds settle and run a rinse/spin cycle without adding detergent.

Reduce the load and retry an empty short cycle only if the drum moves freely.

Open supply valves fully and check inlet hoses and screens.

Inspect the drain hose and clean the pump filter if your model has one.

Check the model manual and request service if 7E returns after a reset.

Confirm the washer is level and stop if the sensor code returns on an empty cycle.

Confirm the washer is on its own circuit and do not use an extension cord.

Stop repeated starts and have the circuit checked if the code returns.

Disconnect power for 5 minutes and request service if communication errors return.

Reduce the load and stop if the motor code returns on an empty test.

Clear the latch area and close the door firmly before restarting.

Confirm the Add Door is fully closed and the latch area is clear.

Check that laundry is not caught in the door and that the latch closes securely.

Stop if the washer overheats, smells hot, or trips protection; service is likely.

Cancel the cycle, watch for continued filling, and turn water off if needed.

Do not force repeated cycles if clutch-position codes return immediately.

Reset once after checking the outlet and breaker; stop if power drops again.

Power reset once, then check the model manual if the same code returns.

Let suds settle, run a rinse cycle, and use less HE detergent next time.

Power reset once; repeated temperature sensor codes should go to service.

Pause, redistribute the load, and avoid washing one heavy item by itself.

Check the drain hose and any accessible drain restriction before retrying spin.

Check for items caught near the door and avoid forcing a locked latch.

Inspect the drain hose and accessible pump filter, then retry a short drain/spin.

Open water valves fully and check inlet hoses and screens.

Use less HE detergent and run a rinse cycle to clear residue.

Check the drain hose height, kinks, and household drain before retrying.

Confirm hot and cold hoses are connected to the correct valves.

Clear the lid lock area and avoid forcing the lid if it stays locked.

Wait for the basket to stop and do not force the lid open.

Open supply valves, check hose screens, and confirm normal water pressure.

Redistribute heavy items and avoid washing one bulky item by itself.

Let suds settle and use less HE detergent next time.