Quick answer
Stop the cycle, turn off water if leaking is active, and inspect visible door or hose areas.
Safety note
Disconnect power before opening panels or touching wiring. If water is leaking near electricity, stop and call a qualified technician.
Related problem hub
See more leak or overflow detection appliance codes across other brands and appliance types.
What Leak Detected means
On many GE Appliances dishwasher models, Leak Detected belongs to the leak or overflow detection category. The appliance has detected water where it should not be, or water level is above expected range.
Codes and exact steps can vary by model number, production year, and regional design. Use this guide as first-pass orientation and confirm model-specific details with the manufacturer source listed below.
Before you start
Write down the full model number and the exact display text before changing parts or clearing the control. Similar-looking codes can map to different model families, and a reset can erase useful timing clues.
If the appliance shows active leaking, a burning smell, smoke, gas odor, repeated breaker trips, or water near power, stop this checklist and use qualified service.
Common causes
- Leak pan or base sensor is wet
- Oversudsing
- Loose hose or drain connection
- Stuck inlet valve
- Door gasket or tub seal leak
Recommended check order
- Confirm the model number and exact code spelling.
- Turn off the water supply if water is actively leaking.
- Disconnect power if water is near an outlet, cord, or control area.
- Look for obvious hose, door, or drain leaks without tipping the unit.
- Let the base dry only after the source of water is understood.
- Run one controlled reset only when the appliance is dry, stable, and safe.
- Stop if Leak Detected returns immediately or appears on an empty test.
Safe checks before service
- Turn off the water supply if water is actively leaking.
- Disconnect power if water is near an outlet, cord, or control area.
- Look for obvious hose, door, or drain leaks without tipping the unit.
- Let the base dry only after the source of water is understood.
What not to do
- Do not restart a dishwasher or washer while active water is leaking.
- Do not reach into standing water around outlets, controls, or wiring.
- Do not bypass locks, sensors, fuses, or leak protection to force a cycle.
- Do not open powered panels or touch wiring for a code check.
- Do not assume one display code proves one specific part has failed.
Stop and call a technician when
- Water is under the appliance.
- The code returns after drying.
- The appliance fills when turned off.
FAQ
Is Leak Detected always a broken part?
No. On a GE Appliances dishwasher, Leak Detected usually identifies a leak or overflow detection category. A blocked hose, dirty filter, uneven load, or unsafe operating condition can trigger a code before a part failure is confirmed.
Can I reset Leak Detected?
A single power reset can be reasonable after visible checks are complete and the appliance is safe. If Leak Detected returns immediately, treat it as an active fault rather than a nuisance message.
Why does model number matter?
Brands reuse similar code text across model families. The model number controls the exact manual steps, access points, and service boundary.
Aliases and related display text
People may search for this same condition using different capitalization or alternate display forms.
- Leak Detected